Yesterday I replaced the master cylinder on my 1997 honda cr125 as the one that was on it was the wrong one.
I connected the brake like and banjo bolt up filled resivour and pumped the handle expecting some bubbles/resistance so that I could then go on to bleed it. But nothing. Handle just hits the throttle.
Took MC off and took banjo bolt out. Pumped the handle and no fluid squirted out the banjo hole. Put my thumb over the hole and no pressure built up when I compressed the lever.
I bought the MC online guy said it was working perfectly. Does it need a rebuild kit or am I doing something wrong?
Users browsing this forum: No registered users and 5 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum